Commercial · Muizenberg
Cold room installation and repairs in Muizenberg
Walk-in cold rooms and freezer rooms built, repaired and kept at temperature for food businesses.
A cold room is only as good as its weakest part: the panel joint, the door seal, the evaporator, the drain or the condensing unit outside. We install cold rooms for restaurants, butcheries, bakeries, bottle stores, guest houses and small food producers, and we repair rooms that are struggling to hold temperature.
Installation covers the insulated panels, door, refrigeration equipment, controls and drainage, with the layout planned around how your staff actually move stock in and out.
What the job includes
- New walk-in cold room and freezer room installation
- Panel, door and seal repair or replacement
- Condensing unit and evaporator replacement
- Defrost, control and temperature logging setup
- Drain tracing, clearing and re-routing
- Temperature recovery and air distribution improvements
Signs you need this
- The room struggles to get below a certain temperature
- Ice builds up on the ceiling, floor or evaporator
- The floor is wet or the drain keeps blocking
- The door seal is torn or the door no longer closes properly
- Temperature swings during busy service periods
How the job runs
- 1
Measure and plan
We check the space, product load, door position and where the condensing unit can be sited.
- 2
Detailed quote
Panel, door, equipment, electrical and drainage scope with the temperatures the room is designed to hold.
- 3
Install or repair
Work is staged so existing stock can be protected where possible.
- 4
Commission and hand over
We set controls, confirm pull-down times and explain the daily checks for your team.
Coastal note
Condensing units sited on a roof or in a salty service yard need clearance and airflow, and their coils need cleaning more often than an inland installation. We allow for that when positioning equipment.
Questions about cold room installation and repairs
Related guides
Related services
Not sure this is the right service? Describe the problem and we will point you to it.