Check the simple things first
Before assuming the worst, confirm the unit is actually being asked to cool. A remote left in heating mode, a timer that has switched the unit off, or a setpoint that is higher than the room temperature will all make a working air conditioner look broken.
- Set the mode to cooling and the setpoint several degrees below the room temperature.
- Replace the remote batteries, or use the wall control if there is one.
- Clean or wash the indoor filters. A clogged filter strangles airflow and can make the coil ice up.
- Check that the outdoor unit is running and that nothing is blocking the coil or the fan.
- Confirm the breaker for the air conditioner has not tripped.
Signs that point to a specific fault
If the basics are fine, the symptom usually narrows the cause. Ice on the indoor coil or the copper pipes suggests restricted airflow or low refrigerant. An outdoor fan that is not turning points to a fan motor or capacitor. A unit that starts, runs for a few minutes and stops may be protecting itself from high pressure, low pressure or an electrical fault.
- Ice forming on the indoor unit or pipes: airflow or refrigerant fault.
- Outdoor fan still while the compressor hums: fan motor or capacitor.
- Unit trips the breaker: electrical fault, do not keep resetting it.
- Error code on the display: note the code down before calling.
Why topping up gas is not a repair
A sealed refrigeration system does not use up its refrigerant. If the charge is low, refrigerant has escaped somewhere, and adding more without finding the leak simply buys a few months before the same failure returns. A proper repair finds the leak, repairs it, pressure tests, evacuates and then recharges to the manufacturer's charge.