Start with how the room is used
A cold room is sized for a certain product load and a certain amount of door opening. During a busy service, doors can be open far more than the design assumed, and warm, humid air enters each time. Stocking the room above its capacity, or putting warm product straight in, has the same effect.
- Keep the door closed and check that it self-closes properly.
- Do not block the evaporator with boxes or shelving.
- Leave space between pallets or crates for air to circulate.
- Pre-cool warm product rather than loading it hot.
- Check the door seal for tears and the curtain for gaps.
Then the equipment
A blocked or iced evaporator cannot move heat, and a defrost cycle that runs at the wrong time will push the room temperature up. Sensor placement matters too: a sensor near the door or in the airflow path reads a temperature that is not representative of the whole room.
When it needs a technician
If the room cannot recover after the doors are closed, if ice is building on the evaporator or floor, if the drain is blocked, or if the compressor runs continuously, the fault is mechanical. Repeated temperature swings are also a food-safety risk, so keep a written log while the issue is being resolved.